Close

ETİKETLENEN KULLANICILAR LİSTESİ

Toplam 1 adet sonuctan sayfa basi 1 ile 1 arasi kadar sonuc gösteriliyor
  1. #1
    Status
    Offline
    ankboy - ait Kullanıcı Resmi (Avatar)
    Erişim Engelli
    Üyelik tarihi
    Feb 2011
    Mesajlar
    0
    Ettiği Teşekkür
    1.966
    Aldığı Teşekkür
    39.081
    Dedikoduları
    534 Post(s)
    Etiketlenmeleri
    4 Thread(s)

    360 HackBox Lite v2.1

    360 HackBox Lite v2.1

    Program özet olarak xebuild görevini görüyor sadece biraz daha detaylı ve görsel özellikleri mevcut





    - Reads NAND twice with a press of a button where it will identify the FlashConfig, Mobo and if it’s a JasperBB it will configure to read 66MB instead of 16MB
    - When opening a NAND image manually it will try to parse the CPU Key from the following in this order: « cpukey.txt », « fuses.txt », « KV_Info.txt ».
    - CPLD Programmer that will flash your Glitch chip with just selecting the version to use
    - Xell Creator for both JTAG and Glitch where it uses IBuild to generate a valid JTAG Xell image.
    Don’t forget to check the « AUD_CLAMP » checkbox if using this config. The ECC creation is already automatic. At the end if any badblocks are found from the source image, it will generate a todo taks
    for when flashing that image.
    - Flashing Xell will flash Xell for you and if during the creation there are bad blocks found it will automaticly fix your NAND.
    - Hacked image creation that uses xeBuild v1.04 and DashLaunch v3.02. It’s automated according to your currently openend nand image. Also it will generate a backup folder according to the console’s serial number so that you may zip up and save.
    - Copy to USB with RawFlash. If you wish to finish you flashing via Xell, this will copy what you need!
    - Save backups to a *.zip where you’ll be prompted to choose destination save file.
    - Flashing the currently opened NAND image. CAREFULL!! it does not verify anything and it will just flash on the fly!
    - Either Download or choose a valid *.zip to copy avatars update to this app. MD5 verification is active.
    - Copy avatars update to your USB so that you may complete the install/update of the hacked dash.
    - Either Download or choose a valid *.zip to install the Kernel pirs that is needed for xeBuild v1.04 to build hacked images. MD5 verification is active.
    - Edit lanch.ini ( basic editor that comes with the most basic options )
    - Download CPU Key and flashdmp.bin from Xell from your PC. No need to specify IP addres or base IP,
    it will detect your computer’s IP and will take that base and search you LAN, may take from 3 to 6 seconds to find and begin the download.
    - Also counts with updating feature online where it will simply let know you if there’s anything new you need to download. ( At last!!! )

    Changelog

    v2.1 Build (300)

    - Added Alternative DGX ECC for flashing ( pop up will show )

    v2.1 Build (299)

    - Added DashLaunch v3.06
    - Added POST_OUT Corona v3/v4 Image

    v2.1 Build (296)

    - Got rid of ibuild and replaced with prebuilt images
    - Touched up the GUI a bit (not very noticeable)
    - Small bugfixes

    v2.1 Build (295)

    - Added support for DGX Thanks to Team Xecuter
    - Added DGX Install Diagram
    - Added DGX ECC files
    - Updated Trinity mobo identify image
    - Note: The « Flash DGX » option will only be available when the CB is not supported by the previous
    ecc Xell generation method and it is only valid for Slim Consoles of course.

    v2.1 Build (294)

    - Internal code serviced ( Optimizations and small bugfixes )
    - Added Mobo Indentify for Trinity and Corona ( Thanks Team Xecuter )

    v2.1 Build (293)

    - Corrected bug that does not enable the « No Bootanim.xex » option for fakeanim

    v2.1 Build (292)

    - Added Support for XeBuild 1.06
    - Added Dashlaunch 3.05
    - Added Support for Dash 16202, creation via xebuild, downloading of pirs and avatars zip
    - Removed restriction to RGH2.0 creation, due to TX-DGX comming, you may build any NAND with glitch2
    settings freely =)
    - « No bootanim » is now default to off since you don’t always have to say no if you don’t want it
    - Added Maximus Stinger v3.1 Oscillator Add-On pcb diagram


    Download:[Linkleri Sadece Kayıtlı Üyeler Görebilir. Üye Olmak için Tiklayın]
    Konu Bilgileri

    Tüm forumdan rastgele konular:

    • » PS Vita için 250 bedava oyun
    • » Grand Theft Auto San Andreas Giriş...
    • » Söylenti: Hacker'lar PSN'i Çökertti
    • » Türkçe yama bu oyun için es geçilmemeli
    • » PES 2011 veri paketi sürüm 7.0 ...
    • » The Last Of Us - The Movie
    • » Xkey için .ISO dosyası Yeniden...
    • » jtag yaptırmak istiyorum
    • » Corei i7 3770 Intel HD4000 Testlerim
    • » Left 4 Dead 2 (PC) İnceleme

    Aynı kategoriden rastgele konular:

    • » RGH/JTAG için Pes13 DLC 6.00 ve TU 1.04...
    • » Injustice Gods Among Us Ultimate...
    • » Xbox360 Dark Void (DLC)
    • » The Sims 3 Xbox360 (DLC)
    • » Pes 2015 Datapack 2
    • » Nfs Rivals Hd Pack Harici Hdd Yükleme...
    • » Xbox360 Killer Is Dead (DLC)
    • » Batman Arkham Origins Test Trainer (+6)
    • » Gta IV (4) Xbox360 Türkçe Yama
    • » Xbox 360 DiRT 2(DLC)


Konu Bilgileri

Bu Konuya Gözatan Kullanıcılar

Şu anda 1 kullanıcı bu konuyu görüntülüyor. (0 kayıtlı ve 1 misafir)

Bu Konu için Etiketler

Bookmarks

Yetkileriniz

  • Konu Acma Yetkiniz Yok
  • Cevap Yazma Yetkiniz Yok
  • Eklenti Yükleme Yetkiniz Yok
  • Mesajınızı Değiştirme Yetkiniz Yok
  •